Default Setting - Hitachi ZW 550-6 Operator's Manual

Default Setting

Function
Auto Shut-Down
Rear View Camera Monitor
Aftertreatment Device Regeneration
Inhibited
Shift Change Delay Mode
(Transmission Setting)
Lockup
Traction Control
Parallel/Tandem Switching Height
Warm Up
f
NOTE: Typical functions are shown in the table. Check the initial values of other functions on each monitor screen.
OPERATOR'S STATION
Item
ON/OFF of auto idling-stop function
Time period for auto idling-stop activation
ON (Constant display)
OFF (No display)
AUTO (Display at reverse operation only)
Inhibit regeneration
ON/OFF of shift (travel speed) change delay mode
ON/OFF of transmission lock-up function
ON/OFF of traction control
Height at parallel or tandem circuit operation are
switched
Increases engine speed at engine start to help
warm up in cold environment
1-20
Default
ON
5 min
AUTO
OFF
OFF
ON
OFF
Lift arm is level to the
ground
OFF