Table of Contents
Advertisement
D. Hydraulic System
Inspection and Maintenance of Hydraulic Equipment
d
CAUTION: During operation, the parts of the
hydraulic system become very hot.
Allow the machine to cool down before beginning
inspection or maintenance.
1. Park the machine following the same procedures as
described on page 7-6 for preparation of inspection/
maintenance work.
2. Begin servicing hydraulic components only after
components, hydraulic oil and lubricants are
completely cooled, and after releasing residual circuit
pressures.
2.1 Release internal pressure.
2.2 Be sure to relieve the air pressure from the
hydraulic oil tank by pressing air bleed valve (1).
2.3 Allow the machine to cool down.
Note that servicing heated and pressurized
hydraulic components may cause hot parts and/or
oil to fly off or escape suddenly, possibly resulting
in personal injury.
Keep body parts and face away from plugs or
screws when removing them.
Hydraulic components may be pressurized even
when cooled.
Service only on a flat, solid and level surface.
MAINTENANCE
7-41
1
115Z7-7-37-1
Advertisement
Table of Contents
Troubleshooting
