Display Assembly - HP Elite Dragonfly G2 Maintenance And Service Manual

Before removing the WWAN antennas and cables, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
4. Remove the heat sink and fan assembly (see
5. Remove the system board (see
6. Remove the speaker assembly (see
Remove the WWAN antennas and cables:
1. Disconnect the antenna cables from the WWAN module (1), and then remove the cables from the clips
on the USB board (2).
2. Disconnect the cable from the ZIF connector on the WWAN antenna (3).
3. Peel the antennas off the computer (4) to remove them.
Reverse this procedure to install the WWAN antennas and cables.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 31).
Heat sink and fan assembly on page
System board on page
Speakers on page
30).
46).
43).
Component replacement procedures
30).
38).
49