Touchpad - HP Elite Dragonfly G2 Maintenance And Service Manual

2. Remove the two Phillips M2.0 × 3.0 screws (2), and then remove the audio board from the computer (3).
Reverse this procedure to install the audio board.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-9 Touchpad description and part number
Description
Touchpad
Touchpad cable (included in Cable Kit, models without WWAN)
Touchpad cable (included in Cable Kit, models with WWAN)
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the touchpad:
1. Disconnect the touchpad cable from the touchpad ZIF connector (1), and then release the cable from the
adhesive that secures it to the touchpad (2).
2. Remove the three Phillips M2.0 × 2.0 screws (3) that secure the touchpad to the computer.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 30).
Battery on page 31).
Spare part number
M42279-001
M42293-001
M48385-001
30).