4
Install the slide rail assemblies
If you do not have enough space around your rack to open the front and back doors
completely, remove the doors before starting this task to allow adequate access.
Determine where in the rack to place the server. This server occupies two EIA units.
4.1
Remove any filler panels necessary to allow adequate access to the location
where you will install your server.
Note: Install units into the lower part of the rack first. Place larger and heavier
units in the lower part of the rack.
Install the slide rail assemblies.
4.2
1.
Pull the front and back blue latch-assembly release tabs
tabs
front and back slide-rail pins
B
to push the latch assembly
A
C
C
into the retracted position. Make sure both
D
are fully retracted.
B
D
C
Front view
A
and use the blue
D