Turbo Mode; Hints And Tips; Care And Maintenance - Russell Hobbs 25200-56 Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Press the + button to start your mixer and increase the speed, press the - button to decrease the
3.
speed. When running the C button light will stay on. Repeatedly pressing the - button will reduce
the speed to zero and stop your mixer. The C button light will flash.
4.
To stop your mixer quickly, press the C button.

TURBO MODE

If you press and hold the + button while your mixer is running, after two seconds, it will run at its highest
speed and continue to do so as long as you hold the button. Release the button and your mixer will revert
to the previously set speed.

HINTS AND TIPS

Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer timings
and slower speeds.
Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and higher
speeds.
Use the whisks for beating/aerating light dough and batter.
Use the hooks for mixing heavier dough (e.g. bread, fruit-cake).
When making dough, use the mixer only for mixing the ingredients. Don't use it for kneading. You'll
overload it and damage the motor.
If the motor starts to labour, add more liquid to the mix, if possible, or switch off and carry on by
hand.

CARE AND MAINTENANCE

1.
Switch the appliance off (0) and unplug it.
2.
Clean the outside surfaces of the appliance with a damp cloth.
` Wash the whisks and hooks in hot soapy water, or in the cutlery basket of your dishwasher.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
4

Advertisement

Table of Contents
loading

Table of Contents