Placement Of The Touch Panel - nilan CTS700 TOUCH Installation Instructions Manual

Placement of the Touch panel

Below is shown how the touch panel can be moved out of the unit. The following page shows how to
mount the wall bracket for the Touch panel.
1. Unscrew the two screws at the top of the lid so it can be
removed.
3. The Touch panel is lifted by pressing the lock clamp at
the bottom.
5. Unscrew the Touch panel wires from the circuit board,
remove the wall bracket and mount it where the Touch
panel is to be hung.
7. Connect the touch panel as shown in the above
diagram, see accompanying electrical diagram. The blue
and blue/white wires should not be used.
Compact P / Compact P Polar - AIR
2. At the top is the aperture plate that is intended to
block the hole when the touch panel is removed.
4. Unscrew the cover and hang it next to the hole.
6. Route the wire from the Touch panel down into the
Compact P, where it is connected to the circuit board.
8. Fix the aperture plate to the cover in front of the circuit
board. Re-attach the lid and secure with the two screws
at the top, giving you a nice white surface.
BY NILAN
25