Water Drainage; The Drain Hose Can Be Connected; To A Stand Pipe With Vent-Hole - AEG 7000 Series User Manual

12 www.aeg.com
O O
20 20
Use the hose supplied with appliance.
Do not use an extension hose if the inlet hose is too short. Contact the
Authorised Service Centre for an inlet hose replacement.

Water drainage

The drain hose can be connected:

O O
45 45
Ø 40 mm
3. Connect the hose to the back of the
appliance. Do not turn the inlet hose
downwards, but turn it left or right depending
on the position of your water tap.
4. Loosen the ring nut to fix it in the correct
position.
5. Connect the water inlet hose to the cold
water tap with 3/4 thread.
WARNING!
Make sure that there are no
leaks from the couplings.

To a stand pipe with vent-hole

Directly into a drain pipe at a height of not
less than 60 cm (23.6") and not more than 100
cm (39.3").
The end of the drain hose must always be
ventilated , i.e. the inner diameter of the drain
pipe (min. 40 mm - min. 1.6") must be larger
than the external diameter of the drain hose.