Table of Contents
Advertisement
Installation
Water inlet
Connect the
water inlet hose
to a separate tap
with a 3/4"
thread.
The other end of
the
inlet
which connects to
the machine can
be turned in any direction. Simply loosen the fitting, rotate the hose
and retighten the fitting, making sure there are no water leaks.
The inlet hose must not be lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at least 60 cm above the
ground.
hose
P1088
75
Advertisement
Table of Contents
