Friedrich Kuhl SM18M30 User Manual page 37

SYSTEM
AUTO
FAN
MODE
CONTINUOUS
FAN
SPEED
M T W T F S S
WAKE
SCHEDULE
If the system mode is set to AUTO (Heat-Cool Unit only), a 2nd temperature
labeled "Heat  Set Point" displays. Use
to increment/decrement the heat temperature. The other parameters
(SYSTEM, FAN SPEED, FAN MODE) cannot be changed on this screen.
The temperature range for AUTO mode must remain a minimum of 3
degrees apart at all times. If the high or low temperature is adjusted too
close to its counterpart, that temperature not being directly changed will
increase/decrease as needed to maintain the 3 degree spread. The user
presses to advance to the next time period.
DISPLAY
ENTER
SYSTEM
FAN
MODE
CONTINUOUS
AUTO
FAN
SPEED
M T W T F S S
WAKE
SCHEDULE
If the user selects FAN-Only mode, the temperature display is replaced by
the word FAN. Options for FAN-Only mode are: CONTINUOUS, adjust
the FAN SPEED; AUTO, fan speed varies depending on system needs.
SYSTEM
FAN
MODE
FAN
SPEED
M T W T F S S
WAKE
SCHEDULE
If the user wants the air conditioner to power down for a period of time,
pressing a fi fth time will set the unit options to OFF and put the unit into
SYSTEM
hibernation until the next scheduled period. This feature is available during
schedule setup only. In on-the-fl y use, the user just presses the power button.
SYSTEM
FAN
MODE
FAN
SPEED
M T W T F S S
WAKE
SCHEDULE
If the user should decide they don't want to use all four time periods for the
day, they can set any period to be skipped by pressing
out the options and display the word SKIP. This can be undone by either
pressing again or pressing the
SYSTEM
The display defaults to the setting immediately prior to the user advancing
to SKIP. Press , to continue on to the next time period.
DISPLAY
ENTER
920-198-00
BACK
HEAT ->SET POINT
F
DISPLAY
ENTER
FRR038
(UP) or (DOWN) arrows
BACK
DISPLAY
ENTER
FRR039
BACK
DISPLAY
ENTER
FRR040
BACK
DISPLAY
ENTER
FRR041
. This will blank
SYSTEM
(UP) or (DOWN) arrows.
Set Schedule – Away, Return, Night Periods
SYSTEM
FAN
MODE
FAN
SPEED
M T W T F S S
SCHEDULE
Each of the additional periods (Away, Return, Night) are programmed
identical to the programming for the Wake period. The appropriate
period identifi er (Away, Return, Night) displays during each programming
sequence.
Once the user has programmed all four (4) time periods, the program goes
to the next day or day group. For example, if individual days are being
programmed, the program will go from Mon to Tues leading the user through
4 periods for Tues until it reaches the end of the week.
NOTE: Day group sequence is as follows: Monday through Friday
(weekday), Saturday – Sunday (weekend), Monday through
Sunday (7-day), and individual days Mon Tue Wed Thru
Fri Sat Sun.
Note that the process follows a continuous loop until the user decides to exit.
When the user has completed setting start times and options (or at any
point in the process) they can press
SCHEDULE
days), or they can press and hold
SCHEDULE
and exit the set schedule mode.
SYSTEM
FAN
AUTO
ROOM TEMP
MODE
AUTO
FAN
SPEED
SCHEDULE
Schedule Mode Completed.
BACK
A
M
AWAY DISPLAY
ENTER
FRR042
to toggle to the next day (or set of
for 3 seconds to save their changes
BACK
SET POINT <- COOL
F
DISPLAY
ENTER
FRR043
37