Table of Contents
Advertisement
Control panel cables for the 5105-22E, 9008-22L,
9009-22A, 9009-22G, or 9223-22H
Find information about removing and replacing the control panel cables in the 5105-22E, IBM Power
System L922 (9008-22L), IBM Power System S922 (9009-22A and 9009-22G), or IBM Power System
H922 (9223-22H) server.
Removing and replacing the control panel cable in the 5105-22E, 9008-22L,
9009-22A, 9009-22G, or 9223-22H
Find information about removing and replacing a control panel display cable for the 5105-22E, IBM
Power System L922 (9008-22L), IBM Power System S922 (9009-22A and 9009-22G), or IBM Power
System H922 (9223-22H) server.
About this task
Note: Removing or replacing this feature is a customer task. You can complete this task yourself, or
contact a service provider to complete the task for you. You might be charged a fee by the service
provider for this service.
If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part in
the system. For instructions, see Repairing a part by using the HMC (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_hmc_repair.htm).
If you do not have an HMC, use the following procedures to remove and replace the control panel cable.
Preparing the 5105-22E, 9008-22L, 9009-22A, 9009-22G, or 9223-22H system to remove
and replace the control panel cable
To prepare the system to remove and replace a control panel cable, complete the steps in this procedure.
Procedure
1. Identify the part and the system that you are working on. For instructions, see Identifying a
part (www.ibm.com/support/knowledgecenter/POWER9/p9haj/sal.htm).
Use the blue identify LED on the enclosure to locate the system. Ensure that the serial number of the
system matches the serial number to be serviced.
2. Use the blue LED to identify the server.
Ensure that the serial number of the system matches the serial number to be serviced.
3. Stop the system. For instructions, see Stopping a system (www.ibm.com/support/knowledgecenter/
POWER9/p9haj/crustopsys.htm).
4. Label and disconnect the power cords from the system unit.
See Figure 25 on page 28.
Notes:
• This system might be equipped with two or more power supplies. If the removing and replacing
procedures require the system power to be turned off, ensure that all the power sources to the
system are disconnected.
• The power cord (B) is fastened to the system with hook-and-loop fastener (A). If you are placing the
system in a service position after you disconnect the power cords, ensure that you unstrap the
fastener.
©
Copyright IBM Corp. 2018, 2020
27
Advertisement
Table of Contents
