Table of Contents
Advertisement
Control panel and control panel display for the
5105-22E, 9008-22L, 9009-22A, 9009-22G, or
9223-22H
Find information about removing and replacing a control panel and control panel display for the
5105-22E, IBM Power
IBM Power System H922 (9223-22H) server.
Figure 1 on page 1 shows the control panel (A) and the control panel display (B).
Figure 1. Control panels
You must have at least one control panel display.
• In the rack-mounted system, a control panel display is required in one of the systems in that rack.
• If multiple systems are installed in multiple racks, a minimum of one control panel display is required in
each rack that contains the systems.
Removing and replacing the control panel in the 5105-22E, 9008-22L,
9009-22A, 9009-22G, or 9223-22H
Find information about removing and replacing a control panel in the 5105-22E, IBM Power System L922
(9008-22L), IBM Power System S922 (9009-22A and 9009-22G), or IBM Power System H922
(9223-22H) server.
About this task
Note: Removing or replacing this feature is a customer task. You can complete this task yourself, or
contact a service provider to complete the task for you. You might be charged a fee by the service
provider for this service.
If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part in
the system. For instructions, see Repairing a part by using the HMC (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_hmc_repair.htm).
If you do not have an HMC, use the following procedures to remove and replace the control panel.
©
Copyright IBM Corp. 2018, 2020
®
System L922 (9008-22L), IBM Power System S922 (9009-22A and 9009-22G), or
1
Advertisement
Table of Contents
