IBM Power System 9040-MR9 Manual page 40

Figure 16. Installing a drive in a system
Important: Ensure that the drive is fully seated and is all the way into the system.
d) Press Enter on the console to indicate that you installed the drive.
6. Continue with step "8" on page 27.
7. To replace a drive by using the Linux operating system, complete the following steps:
a) From the IBM Power RAID Configuration Utility display, select Work with disk unit recovery >
Concurrent add device.
b) Type 1 (Select) next to the location from which you removed the disk drive or solid-state drive.
The Verify Device Concurrent Add display is shown.
c) Unlock the drive bay handle (A) by pressing the handle release latch and pulling out the handle. If
the handle is not all the way out, the drive does not slide into the system.
d) Hold the drive by the top and bottom edges as you position the drive, and prepare to insert it into
the drive slot.
e) Slide the drive halfway into the system.
f) Return to the console, and then press Enter. Verify that the selected slot is the slot in which you
want to install the drive. Press Enter again to confirm the device add operation.
g) When the identify LED flashes for the selected slot, slide the drive all the way into the slot, and
push the drive bay handle (A) in until it locks.
26 Power Systems: Disk drives or solid-state drives