c) Stop the system. For instructions, see Stopping a system (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/crustopsys.htm).
d) If applicable, open the rack door at the rear of the system.
e) Label and disconnect the power cords from the system unit as shown in the following figure.
Notes:
• This system might be equipped with two or more power supplies. If the removing and replacing
procedures require the system power to be turned off, ensure that all power sources to the
system are disconnected.
• The power cord (B) is fastened to the system with a hook-and-loop fastener (A). If you are
placing the system in a service position after you disconnect the power cords, ensure that you
unstrap the fastener.
Figure 11. Removing the power cords
(L003)
18 Power Systems: Disk drives or solid-state drives