Safety Instructions For Users; Safety Instructions For Installers - OSO HOTWATER Maxi Series Safety Information, O&M Information, Installation Manual, Technical Data Sheet

1.2 Safety instructions for users

If a safety valve is fitted, the valve overflow should NOT be sealed or plugged.
The product must NOT be modified or changed from its original state.
Children must NOT play with the product or go near it without supervision.
Maintenance/settings should only be carried out by persons over 18 years of age, with sufficient
!
understanding
The product must not be exposed to frost, over-pressure, over-voltage or chlorine treatment.
See warranty provisions.
Maintenance/settings should not be carried out by persons of diminished physical or mental
capacity, unless they have been instructed in the correct use by someone responsible for their
safety.

1.3 Safety instructions for installers

If a safety valve is fitted (included), the valve overflow should NOT be sealed or plugged.
Any overflow pipe from the safety valve MUST be > 18 mm inside, clear, undamaged and
!
frost-free with a fall to the drain.
!
The relevant regulations and standards, and this installation manual, must be followed.
The product should be placed in a room with a drain, in accordance with the wetroom
standard / latest TEK. Alternatively, fit an automatic stop valve with sensor and overflow
!
from safety valve to drain.
Liability for consequential damage will only apply if this is followed.
The product should be properly aligned vertically and horizontally, on a level floor suitable for
!
the total weight of the product when in operation. See type plate.
The product must have a clearance for servicing of 40 cm in front of front / 10 cm over the top
!
connection.
4
! WARNING
! CAUTION
WARNING
!
! CAUTION