Maintenance - Worx WG163E Manual

WARNING! Only use 1.65mm diameter
cutting line. Other sizes of line will not feed
properly and will result in improper cutting head
function or can cause serious injury. Do not use other
material such as wire, string, rope, etc. Wire can
break off during cutting and become a dangerous
projectile that can cause serious injury.
ASSEMBLY & OPERATION
Action
Assembly
Assembling the Safety Guard
Mounting the Edger Wheel
WARNING: Make Sure
the ON/OFF Switch
is Locked Off to Prevent
Accidental Starting.
Installing and Removing the
Battery Pack
Charging the battery pack
More details can be found in
charger's manual
Checking the battery condition
(Only for WG163E.1, WG163E.2)
Operation
Safety ON/OFF Switch
WARNING! The cutting
12
head continues to rotate
after the trimmer has been
switched off; wait until it has
completely stopped then lay down
the tool.
Trimming
- Adjusting the Shaft
WARNING! Make Sure the
ON/OFF Switch is Locked
Off to Prevent Accidental Starting.
- Adjusting the Trimmer Head
- Adjusting the Auxiliary handle
- Trimming
- Using the Flower Guard
Edging
- Changing the tool into the
Edging mode
- Edging
Command feeding the line
- Note: Press as needed.
20V 2-in-1 Grass Trimmer/Edger
Manually feeding the line
Replacing the trimmer Spool
Manually winding the line
WORKING HINTS
Figure
1. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small
length of line is fed out.
See Fig. A1, A2
A 'clattering' noise will be heard when the lines hit
the Line Cutter. DO NOT BE ALARMED. This is quite
normal. After about 5 seconds the line will be cut to
the correct length and the noise will reduce as the
See Fig. B
motor gains full speed.
If the noise of the line being cut can't be heard, more
line will need to be fed out.
To feed more line, it is first necessary to allow the
trimmer to stop completely; it must come to a
See Fig. C
complete rest, then restart, allowing the motor to
reach full speed.
Repeat above until you hear the line hitting against
See Fig. D1, D2
the Line Cutter.
See Fig. D3
2.
Your grass trimmer is equipped with a Command
Feed System. Just press the button while the
machine is running, new line will feed out and then
stop when you hear the 'clattering' noise of the
new line being cut. The motor stops briefly when
the Command Feed button is pressed, and restarts
See Fig. E
when released. This process enables the machine to
automatically feed out new line.
3. MANUALLY FEEDING THE LINE (See Fig. M)
Press and release manual line feed button (14), whilst
gently pull out the lines until the lines reaches the
line cutter.
If the line extends past the line cutter, too much line
See Fig. F has been fed out.
If too much line is fed out, remove the cutting head
cover and rotate the spool anti-clockwise until the
line is at the desired length.
See Fig. G1, G2
See Fig. H

MAINTENANCE

See Fig. I1
After use, disconnect the battery from the tool and
See Fig. I2
check for damage.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
See Fig. J1, J2 cleaners to clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a dry room
temperature location. Keep the motor ventilation
See Fig. K
slots clean. Keep all working controls free of dust.
See Fig. L
See Fig. M
See Fig. N1, N2,
N3
See Fig. O1, O2,
O3, O4
(See Fig. L)
EN