Table of Contents
Advertisement
Data Reset
The Data Reset function allows you to reset all the programming in the selected model (1 or
2) to the factory default settings. Before using the Data Reset function, it's important to enter
(System Mode)
the Model Select function and check to make sure the current model number indicated (1 or
2) is the model to which you want to reset to the factory default settings. The Model Select
function is described in detail on page 16.
clr
1
Accessing the Data Reset Function
To access the Data Reset function, follow the steps below:
1. Press the SCROLL and CHANNEL keys at the same time and hold.
2. Turn on the transmitter power switch to enter the System Mode.
3. Press the SCROLL key until CLR appears on the screen.
4. Press the INCREASE and DECREASE keys at the same time to reset the data. To
confirm that the selected model's programming has been reset, a beep will sound and
the model number selected (1 or 2) will stop flashing.
5. To exit the System Mode, either turn the transmitter power switch off or press the
SCROLL and CHANNEL keys at the same time.
RF Mode
The DX2.0 features a selectable RF mode. N is the standard RF mode. FR is the France RF
mode and should only be selected if the transmitter is used in France.
Accessing the RF mode Function
To access the RF Mode function, follow the steps below:
1. Press the SCROLL and CHANNEL keys at the same time and hold.
2. Turn on the transmitter power switch to enter the System Mode.
3. Press the SCROLL key until RF appears on the screen.
4. Press the INCREASE and DECREASE keys to select the desired RF mode.
5. To exit the System Mode, either turn the transmitter power switch off or press the
SCROLL and CHANNEL keys at the same time.
18
Indicates model to be reset
RF
Accessing
To enter the Function Mode, turn on the transmitter and then press the SCROLL key. The
display will change to show the first function listed on the Function Mode flow chart as
the Function
shown below. Press the SCROLL key to scroll down through the functions one by one, as
shown in the flow chart. Once the desired function has been reached, use the CHANNEL key
Mode
to select the appropriate channel (if applicable). To adjust the values of the function, simply
press the INCREASE (+) or DECREASE (-) keys until the desired value is displayed on the
screen. To exit function mode, press the SCROLL and CHANNEL keys at the same time.
The next time you enter Function mode, you will be returned to the last function accessed.
st
E P A
I00
L/ F
stS
TRIM
0
st
REV • NORM
tH
Channel
Key
E P A
I00
R/ B
tHS
Channel
Key
TRI M
0
st
Channel
Key
SB-TRM
–
–
REV • NORM
Endpoint
Adjustment
(page 20)
Sub-Trim
(page 21)
Servo
Reversing
(page 22)
19
Advertisement
Table of Contents
