Table of Contents
Advertisement
Quick Links
Owner's Manual V1 - T260S to T380S
Manufacturer: AIR YACHT Ltd - 3 Owens Rd, Epsom - Auckland 1023 - New Zealand - www.takacat.com
Please be sure to observe the information on the type plate attached to the rear-view mirror plate and the
instructions on the inside of the driving tubes.
Summary:
............................................................................................................................................................2
............................................................................................................................................................3
............................................................................................................................................................6
Drainage system
© TAKACAT GmbH - Friedel Hacker (Dipl.-Ing.)
..............................................................................................................................................3
..............................................................................................................................................7
..............................................................................................................................................7
..............................................................................................................................................7
..............................................................................................................................................9
............................................................................................................................................10
Page 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TAKACAT T S Series
Summary of Contents for TAKACAT T S Series
-
Page 1: Table Of Contents
Owner's Manual V1 - T260S to T380S Manufacturer: AIR YACHT Ltd - 3 Owens Rd, Epsom - Auckland 1023 - New Zealand - www.takacat.com Please be sure to observe the information on the type plate attached to the rear-view mirror plate and the instructions on the inside of the driving tubes. -
Page 2: Introduction
Loading must always be carried out with care, distributing loads appropriately to maintain design trim. Heavy loads must be placed as low as possible. • WARNING - Do not exceed the maximum recommended number of people. Regardless of the © TAKACAT GmbH - Friedel Hacker (Dipl.-Ing.) Page 2... -
Page 3: Delivery Package
Takacat to approx. 220 mbar. For Takacats with several hose chambers (T380LX and T420LX), first pump up the rear hose chambers to approx. 150 mbar and then the front hose chambers to approx. - Page 4 Place the two black floor end tabs on the left and right over the lower transom mount and close the respective Velcro fasteners. The middle bottom flap is used for drainage and is simply led outwards below the transom mount. © TAKACAT GmbH - Friedel Hacker (Dipl.-Ing.) Page 4...
-
Page 5: Dismantling
Loosen the fixation of the high pressure floor on the underside of the bow. Open the protective cap of the high pressure bottom valve and set the valve pin to the "deflate" position. Then remove the high pressure bottom and roll it up in the direction of the valve. © TAKACAT GmbH - Friedel Hacker (Dipl.-Ing.) Page 5... -
Page 6: Towing + Anchoring
If there is a large amount of water in the boat, the water must be scooped out of the boat with a bailing ladle, which must always be on board. All SPORT models with open transom are self-draining! © TAKACAT GmbH - Friedel Hacker (Dipl.-Ing.) Page 6... -
Page 7: Important Notes
Takacat, especially the transom construction incl. slip wheels, must be washed with fresh water, rinsed and dried. If you use the Takacat as a tender it is sufficient if the rinsing with fresh water (freshwater) is done after the return to the mother ship. If necessary a stainless steel cleaner and a seawater resistant stainless steel protector is recommended, see www.inoxliner.com... - Page 8 Nevertheless you must avoid contact with sharp-edged objects to prevent damage. It is urgently recommended to move the dinghy with extreme care in areas with low water depth. 11. Avoid damaging the carrying hoses and the high pressure air floor of the Takacat with pointed and/or sharp-edged objects.
-
Page 9: Specifications
6 and the corresponding wave heights (significant wave heights up to 2 m). Such conditions may occur on unprotected inland waters, estuaries and in coastal waters in moderate weather conditions. © TAKACAT GmbH - Friedel Hacker (Dipl.-Ing.) Page 9... -
Page 10: Importer
The specifications of the products which TAKACAT distributes and/or offers as a dealer have been adopted by the respective manufacturer. TAKACAT accepts no responsibility for their accuracy. Maximum specifications apply under optimum conditions (environment, system configuration, software, etc.).
Need help?
Do you have a question about the T S Series and is the answer not in the manual?
Questions and answers