Interface Reconfiguration - Et system LAB-HP/E Series Manual

Ext. Control: Computer
Example:
#1,ID
#22,GTR
#ALL,GTL
The status word can be read with the command
Bit
D15 Parity error
D14 Over run error
D13 Framing error
D12 Timeout error
D11 n/a
D10 n/a
D9 n/a
D8 n/a
D7 Parity enable
D6 Parity mode (1 = odd, 0 = even)
D5 Stop bit (1 = 2 Stop bits; 0 = 1 Stop bit)
D4 Data format (1 = 8 bit; 0 = 7 bit)
D3 n/a
 Table
D2
 Table
D1
 Table
D0
Table: Error messages
D2 D1
0 0
0 1
0 1
1 0
1 0
1 1
Interface parameters are configured via software using the command
<SS>
command .

Interface Reconfiguration

In case, the user has forgotten the active setup, there are two ways of reconfiguring the interface:

sending the command

using the display to configure the interface  Interface Parameters
22
<STB>
or
Function
D0 Error
1 Syntax
0 Command
1 Range
0 Unit
1 Hardware
0 Read
<PCx>
from one of the other interfaces
<*STB?>
. The following functions are assigned to the bits:
<PCx>
. The settings can be saved with the
ET System electronic GmbH