Table of Contents
Advertisement
Antenna and SIM card installation：
IP MODEM antenna interface is for IPEX connector. Buckle the IPEX male head of the
antenna to the antenna interface of IP MODEM, and make sure that the connection is good,
so as not to affect the signal quality.
When the SIM card is installed or removed, follow the icon on the device that indicate
the direction of installation, make sure the SIM card's metal interface is facing down so
that it is in full contact with the socket and be fastened.
2.4 Power introduction
Usually, IP MODEM was embedded to the mainboard of the device. In order to adapt
to the complex application environment and improve the stability of the system, IP
MODEM adopts advanced power technology. It can use DC 3.6-9V to power IP MODEM
directly.5VDC/200mA is recommended.. When power IP MODEM , must ensure power
stability.（Ripple is less than 100mV, and make sure instantaneous voltage does not
exceed 12V), and ensure that the power supply is greater than 1W.
2.5 Indicator
IP MODEM provides four indicators, definition showing as below：Power,Module,
Status,SIM
Xiamen Four-Faith Smart Power Technology Co.,Ltd.
Add：Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen.China
https://en.four-faith.net/
Hotline：400-8838-199
F2X14-E Series IP Modem User manual
Tel： 0592-6300320
Page 12 of 31
Fax：0592-5912735
Advertisement
Table of Contents
