Page 1
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER WARNING! Read this Operator’s Manual carefully before using this machine. Failure understand and follow the contents of this manual may result in electrical shock, fire and/or serious personal injury. READ CAREFULLY HIGH PRESSURE WATER CLEANER...
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER Table of Contents Safety Symbols General Power Tool Safety Warnings Work Area Safety Electrical Safety Personal Safety Tool Use And Care Service High Pressure Cleaning Safety Description, Specifications And Standard Equipment Description Specifications Standard Equipment Machine Assembly &...
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER Safety Symbols In this operator’s manual and on the product, safety symbols and signal words are used to communicate important safety information. This section is provided to improve understanding of these signal words and symbols.
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER • Check for misalignment or binding of moving parts, • Do not eat or smoke while operating or handling high breakage of parts and any other condition that may pressure cleaning equipment. This will help prevent affect the tool’s operation.
G2 High Pressure Cleaner is equipped with a ™ gasoline HONDA engine to drive the triplex plunger pump. ™ Figure.2 - Senator G2 Cold Water Petrol High Pressure Cleaner Standard equipment A Jetwave Senator G2 High Pressure Cleaner comes ™...
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER The machine serial number is located on the frame. The prevent unit damage. first 4 digits indicate the year and month of manufacture Always wear appropriate safety equipment, when inspecting your unit. respectively.
7. Check engine fuel level. If needed, add unleaded 3. Determine the correct equipment for the application. gasoline for Senator G2 Petrol or add diesel for Senator G2D. See engine operator’s manual for 4. Make sure all equipment has been properly inspected.
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER Water Supply Operating Instructions Run a hose from the water source to the unit water inlet. CAUTION Use the largest diameter, shortest length hose possible. A 3/4” I.D. Inlet hose is the minimum recommended size. An appropriate backflow prevention device should be used to comply with all local codes and ordinances.
Page 9
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER 7. With the wand pointed in a safe direction, squeeze the • Be sure that you have good balance and do not have wash wand trigger to reduce pressure and allow the to overreach.
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER Transportation and Storage • Reserve Capacity (RC): 45 • Terminal Type: Offset Lug Terminal (OLT) 1. Turn off the fuel valve and the battery isolation switch. • Assembly Type: C 2. Drain water from unit as needed.
At 1000 hours of use (less in severe use conditions) the unit authorized Jetwave service technician. should be taken to a Jetwave Independent Service Center for pump seal and valve service. Unit should be taken to a Jetwave Independent Service Center or returned to the factory.
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER Trouble Shooting FAULT CAUSE SOLUTION Pump runs normally Pump is sucking air. Check that all hoses and fittings are airtight. but pressure does not Valves are worn or dirty. Check, clean or replace.