Using A Password - Franklin SPQ-200 User Manual

Using a Password

You can use a password to keep the information in
your phone list private. Your password will be re-
quested whenever anyone turns on the unit and first
presses
PHONE
Password Warnings
Warning! After you set the password, you will not be
able to see or use your phone list without it. So always
record your password and keep it in a separate place.
If you forget your password, you must reset the unit to
access the phone list. Your reset button is located in
the tiny hole on the back of the unit. Use the sharp end
of a straightened paper clip to gently press the reset
button. If this does not reset your unit, remove your bat-
teries, wait at least two minutes and then reinstall them.
Warning! Resetting the unit removes your password,
but it also erases all your data, so always keep written
copies of your data.
Password Setup
1. Press
PHONE
2. Use to see Set the password and then press
.
ENTER
3. Type a password and then press
Your password can have up to 23 characters.
4. To test the password, press
word, and then press
5. To disable the password, repeat Steps 1 and 2
above, and then press
word appears.
.
.
11
, type the pass-
ON/OFF
to gain access.
ENTER
when Enter pass-
ENTER
.
ENTER