Table of Contents
Advertisement
1. Touch the button
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
The programme (or the
AT THE END OF THE PROGRAMME
•
The appliance stops automatically.
•
The acoustic signal operates (if it is activated).
•
In the display
comes on.
•
The indicator of the button
•
The door lock indicator
•
You can open the door.
•
Remove the laundry from the appliance. Make
sure that the drum is empty.
•
Press the button
deactivate the appliance.
•
Close the water tap.
•
Keep the door and the detergent drawer ajar, to
prevent the mildew and odours.
The washing programme is completed, but
there is water in the drum:
•
The drum turns regularly to prevent the creases
in the laundry.
•
The indicator
flashes to remind you to drain
the water.
•
The door lock indicator
of button
flashes. The door stays locked.
•
You must drain the water to open the door.
Draining the water:
1. To drain the water.
•
Touch the button
the water and spins with the maximum spin
speed for selected washing programme.
HINTS AND TIPS
WARNING! Refer to Safety chapters.
THE LAUNDRY LOAD
•
Divide the laundry into: white, coloured,
synthetics, delicates and wool.
•
Follow the washing instructions on the laundry
care labels.
•
Do not wash white and coloured items together.
•
Some coloured items can discolour with the first
wash. We recommend that you wash them
separately for the first couple of times.
18
to pause the appliance.
goes off.
again.
) continues.
goes off.
goes off.
for some seconds to
is on. The indicator
. The appliance drains
•
Alternatively, touch the button
the spin speed and then touch the button
. The appliance drains the water and
spins. If you set
drains.
2. When the programme is completed and the
door lock indicator
the door.
3. Press the button
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
AUTO-OFF OPTION
The AUTO-OFF stand-by option automatically
deactivates the appliance to decrease the energy
consumption. All the indicators and the display go
off when :
•
You do not use the appliance for 5 minutes
before you touch the
Press the button On/Off to activate the
appliance again.
•
After 5 minutes from the end of the washing
programme.
Press the button On/Off to activate the
appliance again.
The display shows the end of the last set
programme.
Touch the buttonProgramme if you want to set a
new cycle.
•
Turn multilayered fabrics, wool and items with
printed illustrations inside out.
•
Pre-treat stubborn stains.
•
Wash stubborn stains with a special detergent.
•
Be careful with curtains. Remove the hooks and
put the curtains in a washing bag or pillowcase.
•
A very small load can cause balance problems
with the spin phase leading to excessive
vibration. If this occurs:
a. interrupt the programme and open the
door (refer to "Daily Use" chapter);
b. manually redistribute the load so that the
items are spaced evenly around the tub;
to change
, the appliance only
goes off, you can open
for some seconds to
.
Advertisement
Table of Contents
