Do you have a question about the Lindo 300 ZWF 01483WH and is the answer not in the manual?
Questions and answers
Vivian
April 22, 2025
Machine stopped but I cannot open doot
1 comments:
Mr. Anderson
May 11, 2025
You cannot open the door because the washing programme may not be finished or there is still water in the drum. Set the drain or spin option to remove the water. If needed, perform the emergency drain procedure.
This answer is automatically generated
Alasdair McKeane
March 4, 2025
Is there a filter I can clear? (a large piece of cotton has fallen to pieces in the machine)
1 comments:
Mr. Anderson
May 14, 2025
Yes, the Zanussi Lindo 300 ZWF 01483WH washing machine has a valve filter that should be cleaned regularly.
This answer is automatically generated
Alasdair McKeane
March 4, 2025
Is there a filter I can clean on this machine?
1 comments:
Mr. Anderson
May 14, 2025
Yes, the Zanussi Lindo 300 ZWF 01483WH has a cleanable filter. The manual mentions "Cleaning the inlet hose and the valve filter" as part of care and cleaning instructions.
Do not change the specification of this appliance. • Obey the maximum load volume of 10 kg (refer to the • “Programme chart” chapter). The operating water pressure (minimum and maximum) must be • between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa). www.zanussi.com...
• The appliance must be earthed. • Before you connect the appliance to new • Always use a correctly installed shockproof pipes or pipes not used for a long time, let socket. the water flow until it is clean. www.zanussi.com...
If possible install the appliance in one of the susceptible to vibration. corners of the room, where the floor is more To help prevent vibration we recommend you stable. place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 www.zanussi.com...
: the programme is completed. B) The child lock indicator: Finish In • The indicator comes on when you activate this device. C) The extra rinse indicator: • The indicator comes on when you activate this option. D) The Finish In touchpad. www.zanussi.com...
Cottons 40 °C 1,04 Synthetics 40 °C 0,77 Delicates 40 °C 0,56 Wool/Handwash 30 °C 0,30 Standard cotton programmes Standard 60 °C cotton 1,21 Standard 60 °C cotton 0,84 Standard 40 °C cotton 0,72 1) At the end of spin phase. www.zanussi.com...
Use this option for items with light soil or items You can set from minimum 3 hours to maximum to refresh. 20 hours. The related indicator comes on. www.zanussi.com...
1. Pull the door handle to open the appliance door. 2. Put the laundry in the drum, one item at a time. 3. Shake the items before you put them in the appliance. See in "Settings" how to activate this option. www.zanussi.com...
Page 10
Flap for powder or liquid detergent. • Put the detergent and the fabric conditioner into the compartments. • Carefully close the detergent drawer. Activating the appliance Press and hold for a couple of seconds the button to activate or deactivate the appliance. www.zanussi.com...
Page 11
The display shows the number of hours you set appliance door is locked. The indicator (e.g. ) and the indicator above the button is on to show that his option is active. 2. Touch the button • The door is locked. www.zanussi.com...
• Obey the washing instructions that are on and poppers. Tie up belts. the laundry care labels. • Empty the pockets and unfold the items. • Do not wash together white and coloured • Turn inside out multilayered fabrics, wool items. and items with painted illustrations. www.zanussi.com...
To remove rust particles use only special CAUTION! products for washing machine. Do this Do not use alcohol, solvents or separately from the laundry wash. chemical products. Always obey the instructions that you find on the packaging of the product. www.zanussi.com...
Page 14
4. Put the ends of the drain and inlet hose in a container. Let the water flow out of the hoses. 5. When no more water flows, install the inlet hose and the drain hose again. www.zanussi.com...
Make sure that the filter of the inlet hose and the filter of the valve are not clogged. Refer to “Care and cleaning”. • Make sure that the inlet hose has no kinks or bends. • Make sure that the connection of the water inlet hose is correct. www.zanussi.com...
Page 16
Make sure that you press only the wanted touch button(s). You cannot set an option. After the check, activate the appliance. The If the problem occurs again, contact the programme continues from the point of Authorised Service Centre. interruption. www.zanussi.com...
Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. www.zanussi.com...
Need help?
Do you have a question about the Lindo 300 ZWF 01483WH and is the answer not in the manual?
Questions and answers
Machine stopped but I cannot open doot
You cannot open the door because the washing programme may not be finished or there is still water in the drum. Set the drain or spin option to remove the water. If needed, perform the emergency drain procedure.
This answer is automatically generated
Is there a filter I can clear? (a large piece of cotton has fallen to pieces in the machine)
Yes, the Zanussi Lindo 300 ZWF 01483WH washing machine has a valve filter that should be cleaned regularly.
This answer is automatically generated
Is there a filter I can clean on this machine?
Yes, the Zanussi Lindo 300 ZWF 01483WH has a cleanable filter. The manual mentions "Cleaning the inlet hose and the valve filter" as part of care and cleaning instructions.
This answer is automatically generated