Table of Contents
Advertisement
3. Put the appliance back into an upright position.
Remove the power supply cable and the drain
hose from the hose holders.
WARNING! It is possible to see
water flowing from the drain hose.
This is because the washing
machine has been tested at the
factory.
4. Remove the three transit bolts and pull out the
plastic spacers.
5. Put the plastic caps, that you find in the user
manual bag, in the holes.
We recommend that you keep
the packaging and the transit
bolts for any transport of the
appliance.
INFORMATION FOR INSTALLATION
Positioning and levelling
Adjust the appliance correctly to prevent vibration,
noise and movement of the appliance when it
operates.
1. Install the appliance on a flat hard floor. The
appliance must be levelled and stable. Make sure
that the appliance does not touch the wall or other
units and there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the level. All
feet must rest firmly on the floor.
WARNING! Do not put cardboard,
wood or equivalent materials below
the appliance feet to adjust the level.
The inlet hose
CAUTION! Make sure there is no
damage to hoses and there are no
leaks from the couplings. Do not use
an extension hose if the inlet hose is
too short. Contact the service centre
for a replacement inlet hose.
1. Connect the water inlet hose to the back of the
appliance.
45º
45º
20º
20º
2. Position it toward left or right depending on the
positon of the water tap. Make sure that the inlet
hose is not in vertical position.
3. If necessary, loosen the ring nut to set it in the
correct position.
4. Connect the water inlet hose to the cold water
tap with 3/4'' thread.
Water drainage
The drain hose should stay at a height of no less
than 60 cm and not more than 100 cm.
7
Advertisement
Table of Contents
