Table of Contents
Advertisement
Problem
The programme does
not start.
The appliance fills with
water and drains imme-
diately.
The spin phase does
not operate or the
washing cycle lasts lon-
ger than usual.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes an
unusual noise and vi-
brates.
The programme dura-
tion increases or de-
creases during pro-
gramme execution.
The washing results are
not satisfactory.
Too much foam in the
drum during the wash-
ing cycle.
24
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the
•
If the delay start is set, cancel the setting or wait for the end of count-
down.
•
Deactivate the Child Lock function if it is on.
•
Check the position of the knob on the selected programme.
•
Make sure that the drain hose is in the correct position. The hose may
be positioned too low. Refer to "Installation instruction".
•
Set the spin programme.
•
This problem may be caused by the clogged drain circuit. Please con-
tact the Authorised Service Centre.
•
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
•
Make sure that the couplings of the water hoses are tight and there is
not water leakages.
•
Make sure that the water inlet hose and the drain hose have no dam-
ages.
•
Make sure you use the correct detergent and the correct quantity of it.
•
Make sure that a washing programme that ends with water in tub, has
not been selected.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the drum.
•
Make sure that the appliance receives electrical power.
•
This problem may be caused by a failure of the appliance. Contact the
Authorised Service Centre.
•
Make sure the levelling of the appliance is correct. Refer to "Installa-
tion instruction".
•
Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation instruction".
•
Add more laundry in the drum. The load may be too small.
•
The AutoAdjust System is able to adjust the programme duration ac-
cording to the type and the laundry load size. Refer to "The AutoAdjust
System load detection" in "Daily Use" chapter.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before you wash
the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Reduce the quantity of detergent.
Possible solution
has been touched.
Advertisement
Table of Contents
