USING GWN76XX AS STANDALONE ACCESS POINT
The GWN76XX can be used in Standalone mode, where it can act as Master Access Point Controller or
in Slave mode and managed by another GWN76XX Master.
This section will describe how to use and configure the GWN76XX in standalone mode.
Connect to GWN76XX Default Wi-Fi Network
GWN76XX can be used as standalone access point out of box, or after factory reset with Wi-Fi enabled
by default.
After powering the GWN76XX and connecting it to the network, GWN76XX will broadcast a default SSID
based on its MAC address GWN [MAC's last 6 digits] and a random password.
Note that GWN76XX's default SSID and password information are printed on the MAC tag of the unit as
shown on the below figure.
Figure 30: MAC Tag Label
P a g e
|
53
GWN76XX User Manual
Version 1.0.15.20