Rcom INSECT MAX 140 User Manual page 5

USA & Canada Official Sales & Service https://www.R-Com-Hatcher.com
Identification of Parts
Serial No.
(EX:RCM0000000)
If you register your information with your
machine's serial number on our web-site
(www.Rcom.co.kr), you can get 2 year
warranty service.
Vents for air circulation(Inside)
For circulating warm air
Air inlet vent
For inlet of air
from outside
Main Body-1
Incubation room? It means the place where the incubator is installed and operated, and as it has much effect on
incubation rate according to the environment of incubation room, it is good to install incubator at the place where
there is little noise and vibration in the vicinity and the temperature range isn't severe in the temperature of 22~25
(71.6~77 ℉
from the daytime, it is necessary to check certainly, and during daytime, incubator must not be exposed directly to
the sunlight.
Before inserting eggs, please start incubation after checking if all functions work without any problem by
operating incubator sufficiently.
In case that sight glass and water cap weren't closed completely, temperature and humidity aren't normally
operated. Therefore, please be careful.
In case of moving with water filled, as it may cause a breakdown, fill water after installing it at the place
where you want to incubate.
Please be careful not to give any heavy power or shockon the heater part for humidification in the upper side
of main body as it may be a cause of breakdown. Some foreign substance is created on the heater part
after use, however, there isn't any problem caused of it. (See cleaning method)
DIGITAL INCUBATOR
Insect Incubator Rcom Max 140 User Manual
Digital Control Center
See description of
the function and operation.
). In particular, as there are many cases that the temperature falls rapidly in the nighttime differently
1. Introduction
Power Connecting (the rear)
For connecting
power cord.
Water overflow hole
Main Body-2
Hole that water flows out of the product
automatically when you pour water into the water
hole more than required amount(1300~1400cc).
(2) Identification of Parts
and Composition
Handle
View Window
For a clear view of
the incubation process.
(Double Skin Viewing Window)
Water hole
To facilitate water top-up
for the humidity control.
Locking Button
℃
5