Safety Instructions; Basic Connection; Basic Playback - Pyle PD1000BT User Manual

SAFETY INSTRUCTIONS

1. Make sure that all connections are properly connected and the main volume
is set to minimum level before turning ON the unit.
2. When more then one pair of speakers are used, (specially the main speaker
output) make sure that the speakers used have the same wattage and
impedance, otherwise the unit maybe damaged under high power or long
term operation.
3. To avoid humming sounds and unwanted noise, make sure that all the wires
are properly inserted.
4. For speaker cords, strip o the vinyl coating and twist the wire tip. Push down
the pink jack or loosen the screw terminal, before inserting the wire tip, then
fasten it and tighten the screw. Be careful not to let the wires stick out of the
terminal otherwise this may cause a short circuit when wires of di erent
terminal contact each other.
5. After the unit is turned ON, adjust the main volume to the desired level same
with the bass and treble volume, etc.

BASIC CONNECTION

Connecting to a TV with Audio/Video cable
•
If the TV has an S-video input, connect the DVD player with an S-video cable.
When using an S-video cable, do not connect the yellow video cable.
Note:
The volume adjusting only works when it's connected to a power ampli er.
While it's connected to TV set without speakers, the volume cannot be adjusted
on this device. You can only adjust the volume on the TV set.
10
www.PyleUSA.com
Connecting to an Audio System
Connecting to an Ampli er Equipment

BASIC PLAYBACK

Preparations
•
When you want to view a disc, turn on the TV and select the video input
connected to the unit
Basic Playback
1. Press POWER switch in the front panel to ON, the unit turns on and the TV
screen will display the start logo. If a disc is already in the tray, it will begin to
play once the power is ON.
2. Press OPEN/CLOSE to open the disc tray, place a disc on the disc tray.
•
There are two di erent disc sizes. Place the disc In the correct guide on the
disc tray. If the disc is out of the guide, it may damage the disc and cause
the unit to malfunction.
•
Do not place disc which is unplayable in this unit.
3. Press OPEN/CLOSE to close the disc tray, the playback will automatically start.
•
Some disc may not playback automatically, you can press PLAY button to
start playback.
4. Some disc may start playback with a menu, use the cursor button on the
remote controller to select menu options and press PLAY to start, or press
digits to select a menu options directly.
11
www.PyleUSA.com