Fig. 4-11 Position Of Machine To Bin 12Ft (4 M); Fig. 4-12 Flex Tube Installation - Walinga AGRI-VAC 5614 Operator's Manual And Parts Book

4.9 Machine Preparation
Before the Agri-Vac® can be used it must be
set up and prepared for operation.
When setting-up, follow this procedure:
1. Clear the area of bystanders,
especially small children.
2. Be sure you select a spot that has
sufficient space to locate the machine
and enough clearance to allow trucks
to drive under the discharge cyclone.
3. Position the machine approximately 12
feet (4 meters) from the storage
facility. The PTO shaft should be
straight, by having the tractor and
machine in a straight line.
4. Engage hydraulic lever to operate the
hydraulic circuit.
5. Place all other controls in neutral and
set park brake on the tractor before
dismounting.
6. Remove the plug from the receiver
tank inlet.
7. Remove the intake nozzle from its
storage position on the frame and
install on the end of the steel flex tube.
Secure in position using the wing bolts
on the coupler.
8. Connect the 12 foot steel flex tube to
the inlet. Tighten the wing bolts on the
coupler to lock the tube securely in
place.
Try to have the hose as
straight as possible.
Fig. 4-11 Bin Clearance 12ft (4 M)

Fig. 4-12 Flex Tube Installation.

Agri-Vac Operator's Manual 34-18148-6 32