Fig. 5-21 Adjusting Bolts At Input Shaft; Fig. 5-22 Adjusting Anchor Bolts At Bearing Housing Assembly - Walinga AGRI-VAC 5614 Operator's Manual And Parts Book

5.2.1 BELT TENSION AND ALIGNMENT (cont'd)
7. Pulley Alignment (cont'd):
d. Use the adjusting bolts on the input shaft
to align the input pulley. Tighten jam nuts
when alignment has been completed.
e. Use the bearing housing assembly
anchor bolts to align the blower pulley.
Tighten anchor bolts to their specified
torque.
f. Set the belt tension.
g. Install and secure the belt
cover with two bolts.
8. Be sure all guards are installed and
secure before resuming work.

Fig. 5-21 Adjusting Bolts At Input Shaft.

Fig. 5-22 Adjusting Anchor Bolts At Bearing
Housing Assembly.
Agri-Vac Operator's Manual 34-18148-6 57