Preface - Digital Equipment VAX 4000 Model 200 Installation Manual

Preface

This manual tells you how to install your system, using the following steps.
1. Verify site preparation
2. Check the shipment
3. Position the system
4. Open the system doors
5. Install the console terminal
6. Set the system controls
7. Connect additional devices to the system
8. Connect an expander, if required
9. Connect the KZQSA internal cable, if required
10. Connect the DSSI cable — dual host only
11. Connect the system ground cable — dual host only
12. Connect the system power cable
13. Turn on the system and select a language
14. Close the system doors
If you are installing a dual-host system, you must repeat each step for each
host. For more information on dual-host systems, refer to your system
Operation manual and to VAX 4000 Dual-Host Systems.
A glossary in your system Operation manual will help you understand new
words and abbreviations that appear in this manual.
CAUTION: Before installing the system, review your system warranty. The
terms of your agreement with Digital may require that a Digital service
representative install the system. Contact your local Digital representative
if you have any questions.
If you are installing an expander with your system:
1. Use this manual to begin the installation of the system.
vii