Main Wash Water; First Rinse Water; Final Rinse Water; Low Water Pressure - Miele PWM 508 Mop Star 80 Operating And Installation Instructions

Main wash water

You can select the water type for the
main wash.
- Cold
Only cold water is used for the main
wash.
- Hot
Hot water is also added for the main
wash.
Hot water can only be added if the
wash temperature is above 30 °C.
Programme durations will be longer if
the machine is not connected for hot
water; this may mean that the "Time
left" display is incorrect.

First rinse water

You can select the water type for the
first rinse in some programmes.
- Cold (factory default)
Only cold water is used for the first
rinse.
- Hot
Hot water is also added for the first
rinse.
Supervisor level

Final rinse water

You can select the water type for the
last rinse in some programmes.
- Cold (factory default)
Only cold water is used for the final
rinse.
- Hot
Hot water is also added for the final
rinse (only possible for programmes
with a temperature of at least 60 °C).

Low water pressure

If the water pressure is below 100 kPa
(1 bar), the programme will be can-
celled and the fault message
water inlet will appear.
If the on-site water pressure cannot be
increased, activating the setting
will prevent the programme
ter pressure
from being cancelled.
Factory default: On

Pre-spin mops

In the standard mop programmes, wet
mops are spun briefly at the start of
the programme to remove surplus wa-
ter.
Factory default: On
Check
Low wa-
75