Memory; Auto Load Control; Pre-Wash Water; Main Wash Water - Miele PW 5064 MopStar 60 Operating And Installation Instructions

Memory

If an additional option has been
selected for a programme, or the
recommended temperature or spin
speed has been altered, the machine
will store the changes in memory at
the start of a programme.
When this programme is chosen again
these settings will appear in the
display.
The machine is delivered with the
memory function deactivated.

Auto load control

This machine has fully electronic
controls with automatic load
recognition. If the auto load control is
deactivated, the machine will always
carry out the programme sequence
based on a full load.
The machine is delivered with this
option activated.

Pre-wash water

You can select hot or cold water for
the pre-wash. Hot water can only be
only taken in if the wash temperature
is above 30°C.
The machine is delivered with the Hot
water option selected.
Settings/Supervisor level menu

Main wash water

You can select hot or cold water for
the main wash. Hot water can only be
only taken in if the wash temperature
is above 30°C.
The machine is delivered with the Hot
water option selected.

Rinse water

You can select hot or cold water for
the final rinse cycle in certain
programmes. Hot water can only be
only taken in if the wash temperature
is above 50°C.
The machine is delivered with the Cold
water option selected.

Low water pressure

The Low water pressure setting can
be activated to ensure problem free
water intake where the water
pressure is constantly low (below
100 kPa).
The machine is delivered with this
option deactivated.
65