Weber Q Series Owner's Manual page 13

C) To check for leaks, wet fittings with the soap-and-water
solution, using a spray bottle, brush or rag. If bubbles
form, or if a bubble grows, there is a leak. Apply the
soap-and-water solution to the following connections:
a) Valve-to-regulator hose connection (7).
b) Regulator hose-to-regulator connection (8).
c) Regulator-to-cylinder connection (9).
m WARNING: If there is a leak at connection
(7, 8 or 9), turn off the gas. DO NOT
OPERATE THE GRILL. Contact the
Customer Service Representative in your
area using the contact information on our
web site. Log onto www.weber.com.
D) When leak checking is complete, turn gas supply off at
the source and rinse connections with water.
NOTE: Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
Now you are ready to use your grill.
PREPARING TO USE YOUR GRILL
7
8 9
13
WWW.WEBER.COM