Connecting The Regulator To The Cylinder - Weber 1000 Owner's Manual

CONNECTING THE REGULATOR
TO THE CYLINDER
Only use cylinders with a minimum capacity of 2,5 kg and
a maximum capacity of 13 kg.
A) Connect regulator to cylinder.
WARNING: Make sure that the cylinder
or regulator valve is closed.
Some regulators push ON to connect and pull OFF
to disconnect; others have a nut with a left-hand
thread that connects to the cylinder valve. Identify
your regulator type and follow one of the connection
instructions specific to that regulator.
Connect by Turning Clockwise
Screw regulator onto cylinder by turning fitting
clockwise (1). Position the regulator so that the vent
hole (2) faces down.
Connect by Turning Anti-Clockwise
Screw regulator onto cylinder by turning fitting anti-
clockwise (3) (4).
Connect by Turning Lever/Snapping into Position
Turn regulator lever (5) clockwise to the off position.
Push regulator down on cylinder valve until regulator
snaps into position (6).
Connect by Sliding Collar
Make sure regulator lever is in the off position (7) (10).
Slide the collar of the regulator up (8) (11). Push the
regulator down onto the cylinder valve and maintain
pressure. Slide collar down to close (9) (12). If
regulator does not lock, repeat procedure.
Note: The regulator illustrations shown in this manual
may not be similar to the regulator you are using for your
barbecue, due to different country or regional regulations.

CONNECTING THE REGULATOR TO THE CYLINDER

5
1
2
3
4
6
7
8
10
11
9
12
13
®
WWW.WEBER.COM