Starting the Projectors
Caution
The projector is not lit if a chiller is not working in a
prescribed condition. Start a chiller in advance.
When using a Sony-recommended chiller that is
communicating with the projector, set the chiller to
standby.
1
In the "Status" screen, tap [Standby].
The "Projector Light Control" dialog box will be
displayed.
2
Tap [Power ON].
The MAIN indicators on the rear of the projectors will
turn solid green, and the LIGHT indicators will blink
green.
When the main projector turns on, its MAIN, LIGHT,
and IMB indicators will be solid green.
When the sub projector turns on, its MAIN and
LIGHT indicators will be solid green (its IMB
indicator will remain red).
3
Tap [Close] to close the "Projector Light Control"
dialog box.
The above procedures complete preparations and
confirmation for using the projection system.
Rebooting the System
1
Tap
on the upper right of the screen.
2
Select [Reboot], and then tap [OK].
3
Tap [OK] when the confirmation screen appears.
The server (including the IMB) reboots.
Notes
• The projector itself will not reboot.
• If the projector is lit, it will be turned off, and
entered the cooling state.
18