Figure 10 Port Description - Phihong PoE125U User Manual

To make the factory defaults permanent, the user must click "Save Parameters to
Flash."
The PoE ID field specifies the hardware revision of the PoE device. The firmware
version is represented in a major.minor format.
System ID/Name - click "Edit" to edit/change the description of the system. If you click
"Cancel", the previous description will be set for the system. To make this permanent,
the user must click "Save Parameters to Flash."
A4.4 GUI Port Description:
The Port Description panel shows 8-ports. Each section specifies the individual
port descriptions for the system.
Changes to the port configuration in this section can be enacted when the user clicks the "Send
Port Control" button. It will send the port information to the µP for 24-ports. Please allow the
GUI 10 seconds to refresh when action is taken.
Port Description – Click "Edit" to edit/change the description of the port. Click "Ok" to set
description on the GUI screen. If you click "Cancel", the previous description will be set for that
Phihong USA Corporation • East Coast Engineering Center • 630 Johnson Ave. Suite 102, Bohemia, NY 11716 • Tel: (631) 610-2289
Figure 10: Port Description
www.Phihong.com or www.Midspans.com
30