Connecting Ethernet Cables; Connecting Power Cables; Powering Up - Phihong PoE125U User Manual

2.3

Connecting Power Cables

AC power cord:
The AC power cable is connected to the AC power connector located in the rear side of
the Midspan and the power outlet.
2.4

Connecting Ethernet Cables

Ethernet Cable
The Ethernet cable is connected to the RJ45 connector located in the front side of the
Midspan.
*Ethernet cables are not included
** AC Power Cord may be order separately
2.5

Powering Up

Midspan is powered by the power cord. In order to apply or remove power to/from the Midspan,
connect or disconnect the AC power cable to/from the AC power connector on the rear side of
the unit.
With AC power applied, the unit starts-up and the internal fans are active. The device runs
through a quick power-on test, which takes less than 5 seconds. During this period, all ports are
initially disabled and the port indicators light up. The sequence of the port LEDs are shown in
section 2.6 LED Indicator – Cold Start. Ports are now operating under normal conditions.
Phihong USA Corporation • East Coast Engineering Center • 630 Johnson Ave. Suite 102, Bohemia, NY 11716 • Tel: (631) 610-2289
www.Phihong.com or www.Midspans.com
10