Figure 9 System Information And Port Commands - Phihong PoE125U User Manual

The system level parameters that can be configured are:
• System Reset – This is a function that allows the GUI to reset the software on the µP.
(If System Reset is set and the GUI does not respond, user must click "Reset GUI")
A4.3 GUI System Information:
The System Information panel on the GUI displays information about the
PoE ID, firmware revision, and system status.
Note: Please allow the GUI a few seconds to respond to the commands selected.
DO NOT click or check any commands simultaneously. If a command is selected more
than once within two seconds, the GUI may not respond properly. If the GUI fails to
respond, wait five seconds and then click "Reset GUI" (click "Reset GUI" again if
necessary). Verify that the "System Status" reads "0", which indicates that there is a good
connection.
The "Save Parameters to Flash" button will save system and port parameters to flash
memory, so that they can be used by the firmware across reboots of the µP.
The "Restore Factory Defaults" button will reset the defaults in the firmware, and clear
any stored data in the flash memory, the device will reset automatically. After the device
has successfully reset, the "System Status" will read "0." Click "Reset GUI" if necessary.
Phihong USA Corporation • East Coast Engineering Center • 630 Johnson Ave. Suite 102, Bohemia, NY 11716 • Tel: (631) 610-2289
Figure 9: System Information and Port Commands
www.Phihong.com or www.Midspans.com
29