Transparent Mode Network Configuration; Firewall Configuration - Fortinet FortiGate FortiGate-5001FA2 Installation Manual

Factory defaults

Transparent mode network configuration

Firewall configuration

FortiGate-5000 series Installation Guide
In Transparent mode, the FortiGate-5000 module has the default network
configuration listed in Table
Table 8: Factory default Transparent mode network configuration
Administrator
account
Management IP
DNS
Administrative access
FortiGate firewall policies control how all traffic is processed by the FortiGate-5000
module. Until firewall policies are added, no traffic can be accepted by or pass through
the FortiGate-5000 module. To allow traffic through the FortiGate-5000 module you
can add firewall policies. See the FortiGate Administration Guide for information about
adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
Table 9: Default firewall configuration
Configuration setting Name
Firewall address
Pre-defined service
Recurring schedule
Protection Profiles
The factory default firewall configuration is the same in NAT/Route and Transparent
mode.
01-28011-0259-20060210
8.
User name:
Password:
IP:
Netmask:
Primary DNS Server:
Secondary DNS Server:
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Port 7 (FortiGate-5001SX and
FortiGate-5001FA2 only)
Port 8 (FortiGate-5001SX and
FortiGate-5001FA2 only)
Description
All Firewall address matches the source or
destination address of any packet.
More than 50 Select from any of the 50 pre-defined services
predefined services to control traffic through the FortiGate-5000
module that uses that service.
Always The recurring schedule is valid at any time.
Strict, Scan, Web, Control how the FortiGate-5000 module
Unfiltered applies virus scanning, web content filtering,
spam filtering, and IPS.
admin
(none)
10.10.10.1
255.255.255.0
207.194.200.1
207.194.200.129
HTTPS, Ping
Ping
Ping
Ping
Ping
Ping
Ping
Ping
59