Using The Command Line Interface - Fortinet FortiGate FortiGate-5001FA2 Installation Manual

Transparent mode installation

Using the command line interface

28
To configure DNS server settings
1 Go to System > Network > DNS.
2 Enter the IP address of the primary DNS server.
3 Enter the IP address of the secondary DNS server.
4 Select OK.
To configure the default gateway
1 Go to System > Network > Management.
2 Set Default Gateway to the default gateway IP address that you recorded in
on page 27.
3 Select Apply.
Reconnecting to the web-based manager
If you changed the IP address of the management interface while you were using the
setup wizard, you must reconnect to the web-based manager using the new IP
address. Browse to https:// followed by the new IP address of the management
interface. Otherwise, you can reconnect to the web-based manager by browsing to
https://10.10.10.1. If you connect to the management interface through a router, make
sure that you have added a default gateway for that router to the management IP
default gateway field.
As an alternative to the web-based manager or setup wizard you can begin the initial
configuration of the FortiGate-5000 module using the command line interface (CLI).
To connect to the CLI, see
page 16. Use the information that you gathered in
following procedures.
To change to Transparent mode using the CLI
1 Make sure that you are logged into the CLI.
2 Switch to Transparent mode. Enter:
config system global
set opmode transparent
end
The FortiGate unit restarts. After a few seconds, the login prompt appears.
3 Type admin and press Enter.
The following prompt appears:
Welcome !
4 Confirm that the FortiGate unit has switched to Transparent mode. Enter:
get system status
The CLI displays the status of the FortiGate unit including the following line of text:
Operation mode: Transparent
"Connecting to the command line interface (CLI)" on
01-28011-0259-20060210
Configuring the FortiGate for the Network
Table 4 on page 27 to complete the
Table 4
Fortinet Inc.