AllPondSolutions 400-HO Manual page 3

To ensure your new hang on filter is set up and running
correctly, and to prevent any accidental damage or
injury, please read and follow the below instructions
carefully before using your product.
SAFETY
Important!
before attempting any installation / maintenance of
any kind. Do not attempt to modify this unit in any way
and only use the recommended parts for replacement.
The hang on filter should never be run dry as this will
·
cause the unit to overheat and cause permanent
damage.
All connections must be earthed.
·
The power cord of this appliance cannot be
·
replaced; if the cord is damaged, the appliance
should be discarded. Never cut the cord.
Do not connect to any voltage other than that stated.
·
This filter is suitable for indoor household aquariums
·
only (do not use in exterior locations, swimming
pools, ponds, bathrooms etc). Do not place in
liquids other than water.
Do not use with water above 90F or 30C.
·
Do not carry or pull the unit by its electrical cable.
·
Do not use this unit if it has a damaged cord or plug,
·
if it is malfunctioning or it is dropped or damaged in
any manner
Do not yank cord to pull plug from outlet. Grasp the
·
plug and pull to disconnect. Always unplug an
appliance from an outlet when not in use.
Disconnect the mains electricity supply