Assembly Dimensions Sono-Mix; Assembly Dimensions Sono-Mix Standard - IMKO SONO-MIX Standard User Manual

2017-09-06 User Manual SONO-MIX Version 2_9

4.1. Assembly Dimensions SONO-MIX

4.1.1. Assembly Dimensions SONO-MIX Standard

SONO-MIX can either be installed at the base or the side wall of a mixer. One fact to consider is that the
installation into the mixer base also enables the measurement of smaller material quantities.
A pre-assembled mounting frame is available for the SONO-MIX. The frame can both be welded on to
the base and the side wall of the mixer. The probe can be adjusted to the correct position, respectively
correct installation height with adjusting screws and nuts at the clamping collar.
A cut-out must be performed in the mixer base before welding on the mounting frame and it is
necessary to verify the fit of the frame and the probe at the base, respectively the wall.
Mounting Flange for SONO-MIX Standard
Page 31