16 ELECTRICAL SYSTEM
16.8
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
104
E01030-10
Changing the turn signal bulb
E00360-10
–
3
Press headlight bulb
counterclockwise, and pull it out.
–
Insert the new headlight bulb.
Headlight (HS1 / socket PX43t) (
–
Insert the rubber cap with the bulb socket into the reflector
and turn it clockwise all the way.
Info
Ensure that O-ring
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
p. 69)
–
Check the headlight setting. (
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
p. 69)
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully take off diffuser
–
Lightly squeeze together the orange cap
holding lugs and take it off.
–
Press the turn signal bulb lightly into the socket, turn it coun-
terclockwise by about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers and keep it
free from grease.
–
Press the new turn signal bulb carefully into the socket and
turn it clockwise until it stops.
Turn signal (R10W/socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
lightly into the bulb socket, turn it
p. 133)
4
is seated properly.
p. 102)
p. 108)
p. 105)
p. 43)
p. 107)
p. 71)
1
.
2
in the area of the
p. 133)