Guidance - Oriental motor AZM14*K Series Operating Manual

Guidance

10 Guidance
If you are new to the AZ Series, read this section to understand the operating methods along with the operation fl ow.
 How to read the guidance
This chapter explains the operation procedure as follows.
Home position setting (
Positioning operation (
High-speed return-to-home operation (
10-1 Connection
Wire the driver by reference to the fi gure. Be sure to connect a 24 VDC power supply.
The following explanation is an example for when the built-in controller type driver of 24 VDC is used.
* Cables represented in gray color are accessories. Use the cable for encoder when the length of the encoder cable of
motor is not enough.
▌32

Connection ( p.32)


p.33) *


Trial operation ( p.35)


p.37)

24 VDC power supply
Move the motor to a desired
home position manually.
* Perform the home position setting only once
initially. Once the home position is set, it is no
need to set afterward.

p.38)
Connect to CN3
Cable for encoder
Connect to CN2
Cable for motor
Required
Grounding
PC in which the MEXE02
has been installed