Electric Connections: Wires (Smart 100 12/24V Dc) - Schenker SMART 100 Installation, Use And Maintenance Manual

4 – MOUNTING AND INSTALLATION

4.5.2 Electric connections: wires (SMART 100 12/24V DC)

The electric connectors are positioned inside the small electric box connected to the computer box. The power
supply, coming from the service batteries, needs to be connected to the terminals – and + . The connection
to the boat panel needs to be performed downstream the voltmeter and the ammeter of the boat panelboard.
The connecting terminal must be suitable to support the plant electric load (approx. 500 Watt). A 64 Ampere
automatic circuit breaker for 12V DC systems must be installed on the power supply , while a 32 Ampere for
24VDC systems.
The general wires connection scheme (between the external devices and the main electric box) is the following:
Voltage Automatic
Volt
12
24
The connection general diagram is the following:
Clamp Position
- Pump box
+ Pump box
- Pump box
+ Pump box
P1 Pump box
PS Computer box
PS Computer box
EV Computer box
EV Computer box
Connection between the computer box and remote panel.
Connect the remote panel to the computer box using pre wired cable supplied (standard length 10 mts.)
THE PRESENT MANUAL BELONGS TO -
switch up to 3 mts
Ampere mm2
63 16
32 10
Electric cables and switches selection table
connect to
negative battery
positive battery
Computer box
Computer box
Computer box
Signal pressure switch
Signal pressure switch
electrovalve (on the AC filter)
electrovalve (on the AC filter)
Cable lenght
3 - 7 mt.
AVG mm2 AVG
5 25 3
7 10 7
Schenker Italia
- ALL RIGHTS RESERVED
27
COD. 100S12/24.D.2018
7-10 mt.
mm2 AVG
25 3
10 7
cable section
see table
see table
see table
see table
2,5 mm2
2,5 mm2
2,5 mm2
2,5 mm2
2,5 mm2
EN