Starting The Setup Wizard; Reconnecting To The Web-Based Manager; Connecting The Fortigate Unit To The Network(S) - Fortinet FortiGate FortiGate-200 Installation Manual

Connecting the FortiGate unit to the network(s)

Starting the setup wizard

Reconnecting to the web-based manager

Connecting the FortiGate unit to the network(s)
32
1 In the web-based manager, select Easy Setup Wizard.
Figure 8: Select the Easy Setup Wizard
2 Follow the instructions on the wizard pages and use the information that you gathered
in Table 5 on page 26
3 Select the Next button to step through the wizard pages.
4 Confirm the configuration settings, and then select Finish and Close.
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For example, for each server
located on the Internal network the FortiGate unit adds an External->Internal firewall policy.
If you changed the IP address of the internal interface while you were using the setup
wizard, you must reconnect to the web-based manager using the new IP address.
Browse to https:// followed by the new IP address of the internal interface. The default
address of the internal interface is https://192.168.1.99.
You are now finished the initial configuration of the FortiGate unit, and can proceed to
"Next steps" on page
When you have completed the initial configuration, you can connect the FortiGate unit
between your internal network and the Internet.
There are three 10/100Base-TX connectors on the FortiGate-200:
• Internal for connecting to your internal network
• External for connecting to the Internet
• DMZ for connecting to a DMZ network
Note: You can also connect both the external and DMZ interfaces to different Internet
connections to provide a redundant connection to the Internet.
and Table 7 on page 31
34.
01-28004-0020-20040830
NAT/Route mode installation
to fill in the wizard fields.
Fortinet Inc.