Dhcp Or Pppoe Configuration; Using The Web-Based Manager - Fortinet FortiGate FortiGate-200 Installation Manual

Using the web-based manager

DHCP or PPPoE configuration

Using the web-based manager
26
Table 5: NAT/Route mode settings
Administrator Password:
Internal
External
DMZ
Network settings
You can configure any FortiGate interface to acquire its IP address from a DHCP or
PPPoE server. Your ISP may provide IP addresses using one of these protocols.
To use the FortiGate DHCP server, you need to configure an IP address range and
default route for the server. No configuration information is required for interfaces that
are configured to use DHCP.
PPPoE requires you to supply a user name and password. In addition, PPPoE
unnumbered configurations require you to supply an IP address. Use
record the information you require for your PPPoE configuration.
Table 6: PPPoE settings
User name:
Password:
You can use the web-based manager for the initial configuration of the FortiGate unit.
You can also continue to use the web-based manager for all FortiGate unit settings.
For information about connecting to the web-based manager, see
web-based manager" on page
01-28004-0020-20040830
IP:
Netmask:
IP:
Netmask:
IP:
Netmask:
Default Gateway:
Interface connected to
external network (usually
external):
A default route consists of a default gateway and the name of the
interface connected to the external network (usually the Internet).
The default gateway directs all non-local traffic to this interface and
to the external network.
Primary DNS Server:
Secondary DNS Server:
14.
NAT/Route mode installation
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
Table 6
"Connecting to the
to
Fortinet Inc.