Configuring Fortigate Units For Ha Using The Cli - Fortinet FortiGate FortiGate-200 Installation Manual

Configuring FortiGate units for HA operation
10
12
13
14
15
16

Configuring FortiGate units for HA using the CLI

48
To configure a FortiGate unit for HA operation
1 Go to System > Config > HA.
2 Select High Availability.
3 Select the mode.
4 Select a Group ID for the HA cluster.
5 If required, change the Unit Priority.
6 If required, select Override master.
7 Enter and confirm a password for the HA cluster.
8 If you are configuring Active-Active HA, select a schedule.
9 Select Apply.
The FortiGate unit negotiates to establish an HA cluster. When you select apply you
may temporarily lose connectivity with the FortiGate unit as the negotiation takes
place.
If you are configuring a NAT/Route mode cluster, power off the FortiGate unit and then
repeat this procedure for all the FortiGate units in the cluster. Once all of the units are
configured, continue with
11 If you are configuring a Transparent mode cluster, reconnect to the web-based
manager.
You may have to wait a few minutes before you can reconnect.
Go to System > Status.
Select Change to Transparent Mode and select OK to switch the FortiGate unit to
Transparent mode.
Allow the FortiGate unit to restart in Transparent mode and then power off the
FortiGate unit.
Repeat this procedure for all of the FortiGate units in the cluster.
Once all units are configured, continue with
on page 49.
Use the following procedure to configure each FortiGate unit for HA operation.
To change the FortiGate unit host name
1 Power on the FortiGate unit to be configured.
2 Connect to the CLI.
See "Connecting to the command line interface (CLI)" on page
3 Change the host name.
config system global
set hostname <name_str>
end
"Connecting the cluster to your networks" on page
01-28004-0020-20040830
High availability installation
"Connecting the cluster to your networks"
15.
49.
Fortinet Inc.